Jamara Fokker DVII, Инструкция

Страница: 3 / 28

3
TOP MAIN WING ASSEMBLY
BOTTOM MAIN WING ASSEMBLY
Try to fit the W22 on the main wing as servo tray. Press the W22
into the slots and drop some instant glue to secure it in place.
Try to place the 3mm wide of MW3 on the bottom of the MW2
(the side without any gaps). Use triangle rulerwhen apply instant
glue.
Place W23, W24, W25, W26, W27 as the picture indicated on
the working table.
Close view after gluing MW3 on MW2.
Try to fit the W20 on the main wing (near the leading edge); and
fit the W21 on the main wing near the rear edge. Press them into
the slots and drop some instant glue to secure them in place.
Apply some glue from inside for reinforcement.
Try to assemble W23, W24, W25, W26, W27 and press them into
its relative slots. Make sure the angle must be 90 degree. Drop
some instant glue to secure them in place. Use sand paper to
trim the uneven surface.
Place MW7 (2 pieces), MW8 (2 pieces) and MW9 (2 pieces) on
the working table like the picture shown.
Place W22 on working table.
The assembly of top main wing is completed and wait for apply
film.
Place the MW3 and MW2 on the working table and the slot part
upward.Both parts must be very straight.
Apply glue to secure MW8 on MW9. Please refer to the pic
-
ture. Spread some glue on the surface of MW8 and place MW7
on MW8. Use clip to hold them together until the glue is dried
enough. Make sure the MW9 combinations remain aligned. Drop
some instant glue on the edges.
These two MW9 combinations are for left and for the right.