Jamara Fokker DVII, Инструкция

Страница: 9 / 28

9
RUDDER ASSEMBLY
Try to fit the V1 into the rudder for marking the hinge location
on V1. Use hobby knife to cut the hinge hole on V1. Wait for
applying film.
Place F6 and F7 on the working table.
Use glue to secure the F6 and F7 together. Please note the small
recess on the top of the left sides and the alignment of every
side. Wipe off the excess glue.
Place F20 (2 pieces), F21 and F22 on the working table.
FUSELAGE ASSEMBLY
Place F27 (2 pieces) and one piece of M3 tee nut on the working
table.
Use glue to secure both F27 together.
Hammer M3 Tee nut into F27. Drop some instant glue around
the nut.
Try to place the F21 on F20 and the second F20 on F22. Please
note the holes positions on planking. Use glue to secure them
in place.
Place 4 pieces of F40 on the working table. Use glue to secure 2 pieces of F40 together..
Place F6, F8, F9, F16 on the working table. Please note there is
a small recess on the right top of the F16.
Try t o fit the F6, F8 and F9 in to the F16. Make sure the ang
-
le between F8/F9 and F16 is 90 degree. The cross marking on
the F6 must face outside. The angle between F6 and F16 is 92
degree.
Please note the small recess marking on the F16 and F6 must
on the same side. Drop instant glue to secure F6, F8 and F9
in place.