Jamara Fokker DVII, Инструкция

Страница: 13 / 28

13
The rudder rod tubing will go through the right hole on the F9.
Iron on the covering over the bottom of the fuselage.
After applying the covering on the top and sides of the fuselage;
insert the rod tubing (for elevator rod) through the fuselage and
exit from the preserving holes on the tail.
Place F29, F30, F31, F32, F33, F34, F35 and F36 on the working
table as the picture shown.
The elevator rod tubing will go through the center hole on the F9.
Try t o fit the F30 on F29. Use the F33 as the triangle ruler and
drop instant glue to secure the F30 on F29. Remove F33.
Use hobby knife to cut hole on the right side of tail for exit the
rudder rod tubing.
Use F33 as the triangle ruler and try to fit the F31 on the center
part of F29. Use instant glue to secure the F31 in place. Remove
F33.
FUSELAGE ASSEMBLY
CANOPY ASSEMBLY
Use F33 as the triangle ruler and try to fir the F32 on the tail of
F29. Use instant glue to secure the F32 in place. Remove F33
Completion of the main construction of the canopy. F33 is the
ruler, cannot be fixed into the kit.
Spray the red color onto the white canopy. Wait for it dried
enough.
Apply the masking tape around the edge of the pilot seat. Place paper over other part on the canopy except the pilot seat.
Use the masking tape to secure the paper in place for temporary.
Spray the pilot seat into black. Wait for the spray dried enough.
Remove the masking tape and the paper. Place the canopy and
main construction (with F32 on the right side) on the working
table.