Jamara Fokker DVII, Инструкция

Страница: 24 / 28

24
Use nipple pliers to remove the heads of screws. Use sanding paper to trim the ends of screws. Use wing strut
gauge (including in the hardware bag) as a guide and insert the
screws into the CF tubes to their respective length..
Please refer to the picture and set the length of the screws.
COVERING AND FINISHING THE MODEL
Use instant glue to secure the screws nside the CF tubes. Let
dry.
Use the wing strut gauge as the guide and insert the black plastic
ball-end to both ends of the CF tubes.
Now, there are 6 pieces of long rods and 2 pieces of short rods.
Please use the gauge to make the length is correct.
Place the FRP cowl and venting net on the working table. Try to fit the venting net onto the FRP cowl. Fold the bending part
if necessary. Spread some UHU around the edges for attaching
the venting net. Wait for 2 minutes and attach the venting net
onto the cowl.
Try to press the venting net onto the cowl until the glue dried
enough. It takes around 10 minutes.
Try to install the cowl to the nose, check if it will interrupt the
operation of the propeller. When satisfy the location, use 2.8mm
tapping to secure the cowl in position. It needs to check and set
the operation of the ESC and motor before securing the propel
-
ler. Therefore, please don‘t secure the propeller right now.
If equipped with short motor; please use the plates on F-42 to
make the motor longer.
Place 6 pieces of long carbon fiber tubes, 2 pieces of short car
-
bon fiber tube and 14 pieces of M2 x 25 screws on the working
table.