Jamara Fokker DVII, Инструкция

Страница: 18 / 28

18
Place the ruler on the conjunction of the main wing and aileron.
Use hobby knife to cut the decal and makes the aileron separate
from the main wing.
Remove the aileron and insert the hinges into the slots.
Press the edges of the decal toward the hinge and makes it flat.
Insert the hinges as the picture shown. Spread UHU glue on the
surface of hinges and drop instant glue around the edges of hin-
ges for securing the hinges in place.
Install the aileron onto the main wing. Keep the gap between
main wing and aileron around 0.5mm and drop some instant glue
to secure the hinge into the main wing.
Place the horizontal on the working table. Remove the elevator
from it.
Drop some instant glue to secure the hinges into the elevator. Install the elevator to the horizontal. Keep the gap between ho-
rizontal and elevator around 0.5mm and drop some instant glue
to secure the hinges into the horizontal.
Place the vertical on the working table. Use hobby knife to sepa
-
rate the rudder from vertical.
Drop some instant glue to secure the hinges into the rudder.
There is pre-serving slot on the bottom of the rudder. Try to find
this slot and use hobby knife to remove the covering over this
slot.
Try to find the tail gear from the hardware bag and insert the gear
into the slot. If satisfy the installation, spread some instant glue
on the gear wire and secure it inside the slot.
Covering and complete the model