Chapter 4
Getting Started
4-57
Hint
Never set time of the analogue clock or the internal quartz clock
manually. Observe always the instructions described in chapter
"Set date and time".
After the recorder has been adjusted to the new parameters and the analogue clock
has been synchronised, the current date is displayed.
Make a sample clocking with one of your time card and compare the time printed on
the time card with the time of the analogue clock. If the time on your time card differs
from the time of the analogue clock, the synchronisation must be repeated. See in
section "Set date and time - Synchronise analogue clock" at the beginning of this
chapter.
If you wan to print out all parameter values, you can start now. Insert a protocol card
and proceed as if you would program your recorder by calling-up the programming
routine. Proceed further as described under the topic "Print out all parameters
programmed" in this chapter.
On the following pages a complete protocol report with all explanations is printed.
This is only an example. The values of your protocol report may differ from the
values in this manual, but the dimensions and formats are identical.