4-52
Getting Started
Chapter 4
Hint
Two identical time values for one weekday (e.g. 17:00h for black
and red imprint) cannot be programmed, that means that "E" or
"S" can not be pressed to switch to the next item .
If no ribbon colour change is programmed, all clockings will be printed in black as this
colour is pre-programmed for the printer ex factory.
The programming is identical to the proceeding "Column change timing - standard
recorder with one card lift per day".
D1 = ribbon colour
01 = black
02 = red
- - = erase time value
D2 = Hours
D3 = Minutes
Change or Erase Values for Ribbon Colour Change
All time values programmed can be changed at any time. Proceed as described on
this page.
Proceeding
1.
Call up programming routine (key "
R
").
2.
Select menu "Ribbon colour change" (key "
S
").
3.
Select weekday with time value(s) to be Changed (key "
R
").
4.
Select time value to be Changed (advance with key "
E
").
5.
Change time value (key "
R
").
To Change further values on this weekday repeat steps 4 and 5.
6.
Quit time entry for this weekday (key "
S
").
To Change further values on other weekdays, repeat steps 3 to 6..
7.
Quit menu "Ribbon colour change" (key "
S
").
8.
Quit programming mode (advance to the end of the menu symbols with "
S
")
→
Current date is displayed.
If you want to erase any value of a weekday, proceed as described in above
proceeding. To erase the value displayed, enter "--" in field D1. Confirm with "
E
".
Now the next programmed value is displayed.