Chapter 4
Getting Started
4-65
7.
D1
D2
D3
Enter time of slave clocks at the recorder with
"
R
".
D2 = hours
D3 = minutes
Confirm hours with "
E
".
Enter minutes with "
R
".
8.
Confirm minutes with "
E
".
If the entry has been confirmed with "
E
", all slave clocks will be synchronised
automatically to the current time of the master clock.
This synchronisation can last a few seconds. The recorder returns immediately to
normal operation after synchronisation is finished. Clocking is possible while slave
clocks are synchronised. In standby operation the slave clocks are not supplied.
Card Face Control
If the card face control device is installed, also the function has to be enabled in the
unit. See section "Set Options". The card face control prevents from punching on the
wrong card side
Commissioning after power failure
The recorder need not be programmed after a power failure. Normal operation is
possible when power returns.
All parameter values and settings are stored in the recorder. These values are not
erased by a power failure. Current time and date are also stored due to power
reserve of the recorder. The analogue clock will be synchronised automatically when
power returns.
If the power failure lasted for a longer period, the synchronisation of the analogue
clock with the internal quartz clock can take some longer time.
