Iseki TJ75, Руководство по эксплуатации

Страница: 53 / 117

TJ75
52
FIG. 5-38
FIG. 5-35: Lowering speed can be readjusted as
necessary using lowering rate control knob, 4.
CAUTION: When using mounted implements
with PTO driveline, make sure:
PTO drive shaft has minimum 51 mm (2
engagement of telescoping sections, at all
hitch/implement positions.
Hitch height during raising does not bind
drive shaft universal joints due to extreme
drive shaft angles. Limiting raising height
may be required.
PTO drive is disengaged during transport.
Using Draft Control (accessory)
FIG. 5-36: Type of Work - When ground-engine
implements such as plows, subsoilers, cultivators, etc.
are used.
NOTE: Refer to Rear Linkagefor lockng pin details.
CAUTION: Do not use draft control when
precise hitch positioning is required
(attaching/detaching implements for
example). Using draft control on non be
attempted.
FIG. 5-37: Lever Positions - Use position control lever, 1,
to raise and lower implement.
Position control lever, 1, can also be used to prevent
excessive lowering of hitch when low draft areas (sandy
soil) are encountered.
NOTE: Adjustment dials, 2 and 3, set implement work
or raised position. This enables implement to
be returned to identical setting after hitch has
been raised for turning at field ends.
To Begin Work
- Align Tractor and implement in field
and move position control lever, 1, forward (to DOWN).
while driving Tractor forward, lowering implement.
When Turning - Move position control lever, 1, rearward
to raise implement and permit completion of turn. Return
implement to work position by selecting position control
lever to previous position against stop.
To Finish Work and Transport - Pull position control
lever rearward fully to up setting.
FIG. 5-35
1
FIG. 5-36
FIG. 5-37
1
3 2