Iseki TJ75, Руководство по эксплуатации

Страница: 45 / 117

TJ75
44
POWER TAKE-OFF (PTO)
WARNING: PTO shafts and PTO driven
implements can be extremely dangerous.
Observe the following important points:
DO NOT operate tractor without a PTO cap
installed. The cap protects people from
injury as well as the splines from damage.
Before attaching, adjusting or working on
PTO driven implements, disengage the PTO,
stop the engine and remove the key. DO
NOT work under raised equipment.
Before engaging a PTO-driven implement,
ALWAYS carefully raise and lower the
implement using Position Control. Check
clearances, PTO shaft sliding range and
articulation.
Ensure that all PTO safety shields are in
place at all times.
Ensure all PTO-driven implements are in
good condition and conform to current
standards.
NEVER step across any driveline.
DO NOT use the tractor drawbar or the
implement drawbar as a step.
NEVER use the driveline as a step.
NEVER wear loose fitting clothes.
Keep at least your height away from a
rotating driveline.
Rear PTO Shaft
FIG. 5-14: A six-spline (35 mm) PTO shaft, 1, is provided
at rear of Tractor to provide power for mounted and
other PTO driven equipment as required.
A protective cover is positioned over shaft splines when
not in use.
Normal rear PTO shaft operating speed.
540 rpm @ 2600 engine rpm
1000 rpm @ 2600 engine rpm
IMPORTANT: When rear PTO is used with three-
point mounted equipment, it may be
necessary to remove drawbar, 2, at
rear of Tractor. Some types of mounted
equipment, when lowered, may allow
PTO shaft to contact drawbar.
FIG. 5-15: Implement driveshaft shown connected to
tractor rear PTO shaft.
CAUTION: Make sure all PTO shields are
installed on Tractor and equipment. Before
cleaning or adjusting Tractor or PTO
driven machine, SHUT OFF ENGINE AND
DISENGAGE PTO.
FIG. 5-14
2
1
FIG. 5-15