Invacare Top End Everyday Series, Руководство пользователя

Страница: 63 / 78

6 WHEELS
Part No 1171801
63
Invacare® Top End® Everyday Series
Adjustable Camber System
1. If necessary, open both camber clamps.
2. Loosen the set screw that secures each toe adjustment ring to the axle tube.
3. Using an "L" square, rotate the axle tube until the flat edge of the camber insert is at a 90° angle with the ground/floor as shown.
4. Close the right camber clamp.
5. Rotate the Left toe adjustment ring until the tab stops against the Lower metal tab on the camber clamp.
6. Securely tighten set screw on left toe adjustment ring.
7. Measure the distance between the center lines at the rear and front of the rear wheels at approximately 12 inches (30.48 cm) from the
ground/floor.
8. Perform one of the following:
•
Toe In/Toe Out Measurement is Within ±1/8-inch (.32 cm) - Proceed to step 9.
• Toe In/Toe Out Measurement is Not Within ±1/8-inch (.32 cm) - Repeat steps 1-7 until toe in/toe out measurement is within ±1/8 inch.
9. Open the right camber clamp.
10. Reposition the camber inserts to the highest degree of camber.
11. Repeat STEP 3.
12. Close the left camber clamp.
13. Rotate the right toe adjustment ring until the tab stops against the upper metal tab on the camber clamp.
14. Securely tighten set screw on right toe adjustment ring.
15. Repeat STEP 7.
16. Perform one of the following:
• Toe In/Toe Out Measurement is Within ±1/8-inch (.32 cm) - Proceed to STEP 17.
• Toe In/Toe Out Measurement is Not Within ±1/8-inch (.32 cm) -
i.
Repeat STEP 1.
ii. Loosen the set screw on the right toe adjustment ring.
iii. Repeat STEP 3.
iv. Repeat STEPS 12-16 until toe in/toe out measurement is within ±1/8 (.32 cm) inch.
17. If desired, reposition camber inserts to the desired degree of camber.

Before performing this procedure, make sure the camber inserts are positioned to the lowest degree of camber.