Invacare Top End Everyday Series, Руководство пользователя

Страница: 75 / 78

9 SUSPENSION
Part No 1171801
75
Invacare® Top End® Everyday Series
9 Suspension
9.1 Elastomers and Suspension
Replacing Rear Elastomers
1. Use an allen wrench to hold the outer allen screw.
2. While holding the outer allen screw in position, remove the inner allen
screw from the pivot pin.
3. Use the allen wrench to push the pivot pin with outer allen screw out
of the mounting hole.
4. Remove the existing elastomer.
5. Position the new elastomer between the recess in the axle bracket and
the recess in the suspension base.
6. Compress and hold the elastomer between the axle bracket and the
suspension base.
7. Insert the pivot pin into the mounting hole.
8. Install the outer allen screw into the pivot pin.
9. Use an allen wrench to hold the outer allen screw in position.
10. While holding the outer allen screw, install the inner allen screw into
the pivot pin. Tighten securely.
11. Release when desired speed is achieved.

WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or
damage may occur.
 The performance of the wheelchair will be affected if elastomers are not the same on both sides of the wheelchair.
Outside of Wheelchair
Frame
Outer Allen Screw
Suspension Base
Recess
Elstaomer
Axle Bracket
Recess
Inside of
Wheelchair Frame
Mounting Holes
Inner Allen Screw
Pivot Pin