Invacare Top End Everyday Series, Руководство пользователя

Страница: 52 / 78

6 WHEELS
Invacare® Top End® Everyday Series
52
Part No 1171801
6.9 Adjusting Rear Wheel Camber
Camber Tube with Single Camber
The axle tube must be replaced to change the camber. Refer to
Adjustable Camber System
1. Open the camber clamp.
2. Pull one rear wheel with camber insert out of axle tube.
3. Remove the rear wheel from the camber insert.
4. Rotate the camber insert 180°.
5. Reinstall the rear wheel into the camber insert.
6. Position the camber insert to the desired position. Make sure there
is no more than 3 inches (7.62 cm) (12 indexing marks) of the
camber inserts outside of the axle tube.
7. Slide the indexing ring on the camber insert until it is flush with the
camber clamp.
8. Close the camber clamp. Refer to
9. Repeat STEPS 1-8 for opposite side of wheelchair.
10. Install rear wheel to the wheelchair. Refer to
11. Adjust toe in/toe out of wheelchair. Refer to
 Perform this procedure to one side of the wheelchair at a time for ease of adjustment.
Before using the wheelchair, make sure both camber inserts are set to the same indexing mark. This will make sure the distance between
the rear wheel and the wheelchair is the same on both sides.

WARNING
NEVER position the camber inserts in the axle tube with
more than 3-inches (7.62 cm) (12 indexing marks
showing) of the camber insert outside of the axle tube.
The camber inserts will not be securely tightened in the
axle tube. Possible injury to the user and/or damage to
the wheelchair may occur.
Rear View of Wheelchair
Camber
Clamp
Axle
Tube
Camber Insert -
Rotate 180°
Indexing Ring
Indexing Marks