Invacare Top End Everyday Series, Руководство пользователя

Страница: 54 / 78

6 WHEELS
Invacare® Top End® Everyday Series
54
Part No 1171801
6.11 Adjusting Toe In/Toe Out
Camber Tube with Single Camber
1. Open the camber clamps.
2. Slowly rotate the camber tube in either direction until the rear wheels are approximately in a straight line.
3. Close the camber clamps.
4. Measure the distance between the center lines at the rear and front of the rear wheels at approximately 12 inches (30.48 cm) from the ground/floor.
5. Repeat STEPS 1-4 until the toe in/toe out measurement is less than 1/2-inch (1.27 cm) (0 + 1/4-inch (.63 cm) for maximum rollability).
Adjustable Camber System
Course Adjustment
1. Open the camber clamps.
2. Loosen the Phillips™ screws that secure the adjustment rings to the axle
tube.
3. Slowly rotate the axle tube until the rear wheels are approximately in a
straight line.
4. Close the camber clamp.
5. Measure the distance between the center lines at the rear and front of
the rear wheels at approximately 12 inches (30.48 cm) from the
ground/floor.
6. Repeat STEPS 1-4 until the toe in/toe out measurement is less than
1/2-inch (1.27 cm) (0 + 1/4-inch (.63 cm) for maximum rollability).
7. Rotate either the right or left adjustment ring until the stop on the ring is
at the top of the slot in the camber clamp as shown and securely tighten
the Phillips screw on the positioned adjustment ring.
 This procedure is required any time the axle tube is moved from the factory set position or is replaced.
Make the following adjustment for one camber at a time.
Rear wheels are removed from the drawings for clarity. There is no need to remove rear wheels from the wheelchair during adjustment.
The illustration shows two examples of how the adjustment rings can be positioned.
 DO NOT tighten the Phillips screw on the other
adjustment ring at this time.
Repeat STEPS 1-7 of this procedure for the other
adjustment ring after repositioning the camber insert.
Axle Tube - Rotates Up and Down