Invacare Top End Everyday Series, Руководство пользователя

Страница: 60 / 78

6 WHEELS
Invacare® Top End® Everyday Series
60
Part No 1171801
5. Adjustable Camber System Only - Loosen, but DO NOT remove the two Phillips screws that secure the toe adjustment rings to the axle tube.
6. Pull the existing axle tube through one of the camber clamps.
7. Adjustable Camber System Only - Remove toe adjustment rings from the existing axle tube.
8. Pull the existing axle tube through the other camber clamp and remove from the wheelchair.
9. Slide the new axle tube through one of the camber clamps.
10. Adjustable Camber System Only - Install the adjustment rings onto the new axle tube. Make sure the stops on the adjustment rings are facing
towards the outside of the wheelchair.
11. Slide the new axle tube through the other camber clamp until the axle tube is evenly spaced between the camber clamps.
12. Adjustable Camber System Only - Install camber inserts into the new axle tube and slide the camber inserts to the position noted in STEP 1.
Make sure there are no more than 3 inches (12 indexing marks) of the camber inserts outside of the axle tube.
13. Adjustable Camber System Only - Slide the indexing ring on the camber insert until it is flush with the camber clamp.
14. Install the rear wheels onto the wheelchair.
15. Adjust the axle tube.
 Adjustable Camber System Only - Make sure the notches in the axle tube are towards the rear of the wheelchair and the slots in the
axle tube are facing up.

DO NOT tighten the Phillips screws that secure the adjustment rings to the axle tube at this time.

DO NOT close the camber clamps at this time.

WARNING
NEVER position the camber inserts in the axle tube with more than 3 inches (7.62 cm) (12 indexing marks showing) of the camber insert
outside of the axle tube. The camber inserts will not be securely tightened in the axle tube. Possible injury to the user or damage to the
wheelchair may occur.
 To maximize rollability: Before using the wheelchair, make sure both camber inserts are set to the same indexing notch. This will make
sure the distance between the rear wheel and the wheelchair is the same on both sides.