Invacare Top End Everyday Series, Руководство пользователя

Страница: 71 / 78

8 FOOTREST/ANTI-TIPPER
Part No 1171801
71
Invacare® Top End® Everyday Series
Adjusting Footplate Depth
1. Loosen, but DO NOT remove the four flat screws and locknuts that secure footplate to the footrest tubes.
2. Move the footplate to one of two positions to accommodate the user.
3. Retighten the four flat screws and locknuts.
8.4 Adjusting/Replacing Anti-Tipper
Adjusting Anti-Tipper
1. Press in the release button that secures the anti-tipper wheels to the anti-tipper bar.
2. Adjust the height of the anti-tipper wheels to between 1-1/2 and 2-inches (3.81 to 5.08 cm) of the ground/floor.
3. Repeat STEPS 1-2 for the opposite anti-tipper.
 Observe the angle of the footplate.
 The settings for positioning the footplates on the half-clamps may vary for each user.
The locknuts should lie in the channel of the footplate half clamp.

WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or
damage may occur.
Anti-tippers MUST be attached at all times. Inasmuch as the anti-tippers are an option on this wheelchair (you may order it with or
without the anti-tippers), Invacare strongly recommends ordering the anti-tippers as an additional safeguard for the wheelchair user.
Anti-tippers MUST be fully engaged. Ensure the release button of the anti-tipper fully protrudes out of the hole in the anti-tipper socket.
Ensure both anti-tippers are adjusted to the same height.
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 1-1/2 to 2-inch (3.81 to 5.08 cm) clearance between the bottom
of the anti-tipper wheels and the ground/ floor. This spacing should always be checked whenever adjustments/changes are made to the
wheelchair. Failure to maintain proper spacing may result in the chair tipping over backward causing serious injury or property damage.
 Measurements for anti-tippers are approximate and are taken using the top adjustment hole on the anti-tipper.