Invacare TDX 3, Руководство пользователя

Страница: 37 / 72

Part No. 1114809
37
TDX WHEELCHAIRS
SECTION 4 FRONT RIGGINGS
FRONT
RIGGINGS
70
O
TAPER (FIGURE 2)
1. Turn the footrest to the side (open
footplate is perpendicular to wheel-
chair itself).
2. Insert footrest mounting pin into
mounting tube.
3. Push the footrest towards the inside
of the wheelchair until it locks into
place.
NOTE: The footplate will be on the inside of
the wheelchair when locked in place.
4. Repeat STEPS 1- 3 for the other
footrest assembly.
5. To remove the footrest, push the footrest release lever inward, rotate footrest
outward.
6. Refer to FOOTREST HEIGHT ADJUSTMENT in this section of the manual.
FIGURE 2 - INSTALLING/REMOVING
FOOTRESTS - 70
°
, TAPER
Footrest
Mounting Pin
Footplate
Footrest
Release Lever
Mounting Tube
FOOTREST HEIGHT ADJUSTMENT
70
O
, PW93 (FIGURE 3)
WARNING
Minimum ground clearance for footrest is 3-inches - otherwise personal
injury and damage may result.
1. Remove any accessory from the footrest(s).
2. Remove the footrest from the wheelchair. Refer to INSTALLING/REMOVING
FOOTRESTS in this section of the manual.
NOTE: Lay the footrest on a flat surface to sim-
plify this section.
3. Remove the mounting screw, washers and
locknut that secure the lower footrest to the
footrest support.
4. Reposition the lower footrest to the desired
height.
5. Reinstall the mounting, washers and locknut
that secure the lower footrest to the foot-
rest support and tighten securely.
6. Repeat STEPS 1-5 for the opposite side
of the wheelchair footrest, if necessary.
7. Reinstall the footrest(s) onto the wheelchair. Refer to INSTALLING/REMOVING
FOOTRESTS in this section of the manual.
8. Reinstall any accessory onto the footrest(s).
FIGURE 3 - FOOTREST HEIGHT
ADJUSTMENT - 70
°
, PW93
Lower
Footrest
Assembly
Mounting Screw
Washer
Locknut
Upper
Footrest
Support
All manuals and user guides at all-guides.com