Part No. 1114809
39
TDX WHEELCHAIRS
ADJUSTING/REPLACING TELESCOPING FRONT RIGGING
SUPPORT (FIGURE 6)
WARNING
If the telescoping tubes need to be extended greater than 2-inches then
the seat must be repositioned rearward to ensure stability - otherwise
personal injury and/or damage to the wheelchair and surrounding prop-
erty may result.
1. Remove the two (2) mounting screws, spacers and locknuts that secure the tele-
scoping front rigging support to the seat frame.
2. Perform one (1) of the following:
A. Slide existing telescoping
front rigging support to one
(1) of three (3) depth posi-
tions.
B. Remove existing telescoping
front rigging.
3. Secure telescoping front rigging at
desired depth with existing two
(2) mounting screws, spacers, and
locknuts. Securely tighten.
NOTE: The two (2) telescoping front rigging supports can be positioned at different depths de-
pending on the need of the user.
FIGURE 6 - ADJUSTING/REPLACING
TELESCOPING FRONT RIGGING
SUPPORT
Mounting Screws
Seat Frame
Spacers
Locknut
Telescoping
Front Tube
INSTALLING ADJUSTABLE ANGLE FLIP-UP FOOTPLATE
HINGE (FIGURE 7)
1. Position adjustable angle flip-up footplate (
footplate
)
hinge on the footrest support
tube at the desired height.
2. Position mounting screw, washers, spacer, and locknut on the footrest support as
shown in FIGURE 7.
3. Flip the footplate hinge to the UP position.
NOTE: The footplate hinge will fall to the DOWN position.
4. Tighten the mounting screw, washer, and locknut that secure the footplate hinge to
the footrest support until the footplate hinge remains in the UP position.
5. Check the up and down motion of the footplate hinge to make sure the user of the
wheelchair can operate the footplates easily.
NOTE: If footplate's motion is too tight, loosen the mounting screw and locknut approximately 1/
4-turn counter clockwise.
NOTE: If the footplate's motion is too loose, tighten mounting screw and locknut approximately 1/
4-turn clockwise.
6. Adjust footplate. Refer to INSTALLING/ADJUSTING ADJUSTABLE ANGLE FLIP-
UP FOOTPLATES in this section
of the manual.
SECTION 4
FRONT RIGGINGS
FRONT
RIGGINGS
All manuals and user guides at all-guides.com
