Part No. 1114809
53
TDX WHEELCHAIRS
FIGURE 2 - REMOVING BATTERIES FROM WHEELCHAIR
Disconnect batteries from the
controller HERE. (STEP 5)
NOTE: Only the TDX base is shown
for clarification purposes.
Thumb Screws (STEP 3)
Rear Shroud
(STEP 4)
Battery Door
(STEP 7)
Mounting
Screws
(STEP 6)
Mounting
Screws
(STEP 6)
GP24 Batteries
with GP24 battery
tray (STEP 9)
Disconnect front battery from
the rear battery here
(STEP 10)
Battery
Straps
(STEP 9)
REMOVING/INSTALLING BATTERIES FROM/INTO
WHEELCHAIR
REMOVING (FIGURE 2)
1. Place the wheelchair in a well ventilated area where work can be performed without
risking damage to carpeting or floor covering.
2. Verify the joystick ON/OFF switch is in the OFF position.
3. Remove the two thumb screws that secure the rear shroud to the chair.
4. Remove the rear shroud from the chair.
5. Disconnect the controller from the batteries at the rear of the chair.
6. Remove both mounting screws from side of battery door.
7. Remove battery door from front of chair.
8. Slide battery tray with batteries out.
9. If wheelchair is equipped with ventilator tray refer to REMOvING VENTILATOR
BATTERY in this section of the manual.
10. Disconnect battery straps.
11. Unplug front battery from rear battery.
12. Remove the front battery.
13. Slide the rear battery forward and remove it
from the tray.
SECTION 7
BATTERIES
BATTERIES
22NF
Batteries
with 22NF
battery
tray
All manuals and user guides at all-guides.com
