Intermec Trakker Antares 2475, Руководство пользователя

Страница: 59 / 104

Chapter 3— Operating the Terminal in a Network
Trakker Antares 2475 Vehicle-Mount Terminal User’s Manual 45
With this protocol, you cannot configure values for intercharacter delay,
turnaround delay, and timeout delay. This protocol supports CTS/RTS
flow control only.
Using RF Communications on the Terminal
Make sure all components with antennas are at least 30 cm (1 ft) apart
when power is applied. Failure to comply could result in equipment
damage.
Attention: Assurez-vous que la distance entre tous les éléments avec
antennes soit d'au moins 30 centimètres (un pied) avant de faire la
connexion avec l'alimentation électrique, faute de quoi vous risquez
d'endommager votre installation.
You can use the 2475 to transfer data using RF communications. Before
you can use RF communications, you must perform these steps:
1
Plan and prepare your RF network. For help, see the next section,
“Planning the Network Connection.”
2 (UDP Plus or WTP network only) Configure the Intermec Gateway
or DCS 30X. For help, see “Configuring the Intermec Gateway or
DCS 30X” on page 46.
3
Configure the access points. For help, see “Configuring the Access
Points” on page 47.
4 Configure the network parameters on each terminal in the network. For
help, see “Configuring the 2475 Network Parameters” on page 48.
5 (802.1x security) Configure the 802.1x security parameters on each
terminal in the network. For help, see “Configuring the 802.1x Security
Parameters” on page 49.
Note: You can also configure parameters for multiple terminals in your
RF network using the Wavelink Avalanche client management system
and the Intermec Settings application. For help, see Chapter 2,
“Configuring and Managing the Terminals,” in the
Trakker Antares
2400 Family System Manual (P/N 071389).
The set of network parameters you must configure depends on whether
you install the terminal on the same subnetwork as the Intermec Gateway
or DCS 30X (UDP Plus or WTP) or host (TCP/IP) or on a different
subnetwork. For help determining which network parameters you must
configure, see “Configuring the 2475 Network Parameters” on page 48.