Intermec 502O, Руководство пользователя

Страница: 309 / 402

nuggetf
code39
Troubleshooting
9-7
9
Problems While Operating the 5020 (continued)
Problem or Message Solution
While using the Visual Studio tools, you are
unable to establish a connection to the 5020.
1. Make sure the WINS or DNS network configuration is correct and
that you have access to a WINS or DNS server.
2. Exit all Visual Studio tools. Use Task Manager to verify that the
CEMGR process is not running. End the process if it is running.
3. Set up the Visual Studio tools for remote debugging.
Problems While Configuring the 5020
Problem or Message Solution
You changed the radio, Ethernet, or UDP Plus
parameters, such as DHCP enable or the 5020
IP address, but the parameters did not take
effect on the 5020. Press
' twice to suspend and resume the 5020 and have the changes
take effect.
If you have DHCP enabled and the DHCP-assigned parameters are not
displayed, select the Refresh button in the Configuration application or
Unit Management.
You enabled or disabled UDP Plus in the
Advanced tab of the Network menu in the
Configuration application or remote Unit
Management but the change did not take
effect on the 5020. Warm boot the 5020 to enable the change. For help, see “Booting the
5020” later in this chapter.
You have an Ethernet PC card installed but
the Ethernet tab does not appear in the
Network menu of the Configuration
application or remote Unit Management
application. Warm boot the 5020 to initialize the PC card then restart the
Configuration application or Unit Management. For help booting the
5020, see “Booting the 5020” later in this chapter.
You try to configure the 5020 using SNMP
and SNMP does not work. Check community strings, IP addresses, and whether encryption is
turned on or off. If encryption is on, turn it off. (SNMP encryption only
works with Intermec software that supports it.) For help, see
“Configuring the 5020 by Using SNMP” in Chapter 3.