Intermec 502O, Руководство пользователя

Страница: 233 / 402

Nugg
Co d e 39
Configuration Command Reference
8-31
8
Notes: If you configure Standard Code 128, the 5020 will not decode Function Code 1
characters in the first position of a bar code label. Any subsequent Function Code 1
characters are translated to the ASCII GS character as a separator for variable length
fields.
If you configure UCC/EAN Code 128, the 5020 will decode a bar code label as
Standard Code 128 unless one of the first two characters are a start character and a
Function Code 1. In this case, the bar code label is processed as described next:
1. The Function Code 1 character is not transmitted.
2. The three symbology ID characters, ]C1, are transmitted.
3. The remaining Code 128 characters are decoded as Standard Code 128.
Configuration Manager Enable
Purpose: This Network menu command is reserved for future use. Intermec strongly recommends
that you leave this command enabled so it is set correctly for future upgrades. After you
change this parameter, warm boot the 5020 to make the change effective.
Configuration: Use one of these methods:
Configuration
Applications
SNMP Bar Codes
Yes Yes No
In the Configuration or Unit Management application, choose Configure and then
Network. Next, choose Advanced and then choose Config Manager Enable. For help,
see Chapter 3, “Configuring the 5020.”
On Cold Boot: Saved
SNMP OID: 1.3.6.1.4.1.1963.15.501.7.1.0
Options: Acceptable values for the configuration manager parameter are:
0 Disabled
1 Enabled
Default: Enabled