71
To add or replace an internal-access peripheral device:
WARNING
The system is always on when connected to AC power. Before performing this
task, disconnect the system’s power cord from its AC power outlet.
1.
Disconnect the power and data cables from all of the devices in the internal-access device
cage. Note which cables connect to each device.
2.
Remove and retain the screw securing the cage to the base unit chassis.
3.
Push the release lever and slide the cage back, down, and out of the base unit chassis.
4.
If replacing an internal-access device, remove and retain the screws securing the device to the
cage, and remove it from the cage.
5.
Place the new device in the cage and secure it with the screws removed previously.
6.
Align the tabs on the top of the internal-access device cage with the openings in the bottom of
the front-access device cage. Then push the release lever, and slide the cage up and forward
into the base unit chassis until the release lever engages.
7.
Secure the cage to the base unit chassis with the screw removed previously.
8.
Connect the power and data cables to all of the devices in the cage.
Device Cage Screw
Release Lever
(push in)
Device Screws
(both sides)
Power and Data
Cables
