62
See Chapter 10, “Servicing System Components,” for instructions to replace or add an internal
peripheral device. See the System Board Manual for details on EIDE and SCSI device power and
data connections to the system board.
Remember the following when installing internal-access SCSI peripheral devices:
♦
The maximum speed of a SCSI bus is limited to the speed of the slowest device on that bus.
♦
Have the vendor’s documentation available to follow instructions for setting the SCSI ID,
enabling or disabling termination, installing device drivers when required, and configuring
other drive attributes.
♦
If you are installing a internal peripheral device that connects to an expansion card, see the
vendor’s documentation for installing the expansion card and required cables. See “Adding
Expansion Cards” for details.
Adding External SCSI Peripheral Devices
The system has a Symbios single-channel low-voltage differential signaling (LVDS) Wide Ultra2
SCSI controller card. You can connect Fast, Ultra, or Ultra2 SCSI devices to the card’s external
port. See Chapter 1, “Setting Up the Hardware,” to locate the SCSI port.
Bay 1
Bay 2
Bay 3
Bay 4
Bay 5
Bay 6
Bay 7
