49
Parameter
Description
Standby / Suspend Timer Unit
Sets the period of time for Standby and Suspend time-outs. The
Optimal default is 4 minutes.
Standby Time Out
Sets the period of system inactivity while in Full On state. The
Optimal default is Disabled.
Suspend Time Out
Sets the period of system inactivity while in Standby state. The
Optimal default is Disabled.
Slow Clock Ratio
Sets the speed at which the system clock runs in the Standby
state. The Optimal default is 50%-62.5%.
Display Activity
Sets support for event monitoring on the video display. The
Optimal default is Ignore.
Device n
Sets support for event monitoring on the specified device. The
Optimal default is Ignore. The devices are 0 (primary master
IDE), 1 (primary slave IDE), 2 (secondary master IDE), 3
(secondary slave IDE), 5 (floppy disk), 6 (serial port 1), 7
(serial port 2), and 8 (parallel port).
LAN Wake-Up
Sets support for Wake-on-LAN. The Optimal default is
Disabled.
PC98 Power LED
Sets support for PC98 power LED use. The Optimal default is
Disabled.
FAN OFF at Suspend
Sets support to turn off the processor fan when the system is in
Suspend state. The Optimal default is Enabled.
RTC Wake-Up
Sets the hour and minute for the system to wake up. The
Optimal default is Disabled.
PCI/Plug and Play Setup
Parameter
Description
Plug and Play Aware O/S
Sets support for a Plug and Play (PnP)-aware operting
system. The Optimal default is No.
PCI Latency Timer
Sets the latency timings for PCI devices installed in the PCI
expansion slots. The Optimal default is 64.
PCI VGA Palette Snoop
Sets support for multiple VGA devices operating on
different buses to handle data from the processor on each set
of palette registers on every video device. Set to Enabled if
an installed ISA adapter card requires VGA palette
snooping. The optimal default is Disabled.
Allocate IRQ to PCI VGA
Sets an IRQ to the VGA device on the PCI bus. The
Optimal default is No.
