Intel M20NTP1UR, Руководство по системной интеграции и обслуживанию

Страница: 43 / 114

Intel® Server System M20NTP1UR - System Integration and Service Guide
43
3.9 Trusted Platform Module (TPM) Installation
This section provides instructions to install a Trusted Platform Module (TPM) in the system. Refer to the
Intel® Server M20NTP Family Configuration Guide for available options.
Required Tools and Supplies
• Intel® TPM Accessory Kit: iPC JNPTPM or iPC JNPTPMCH
•
Mounting hardware – included with TPM kit
• Slot-Head Screw Driver
•
Anti-static wrist strap and conductive workbench pad (recommended)
1. Power off the system and disconnect the power cable(s).
2. Remove the system top cover (see Section 3.1.1 ).
3. Remove the Air Duct (see Section 3.2.1 ).
4. Remove the riser card assembly (see Figure 26 ).
5. Locate and unpack the TPM accessory kit: TPM mounting hardware
6. Locate the 16-pin TPM connector found near the back edge of the server board.
7. Install the mounting hardware and TPM onto the server board (See Figure 45 )
Figure 45. TPM Placement
•
Install the TPM mounting stand-off into the stand-off slot on the server board (See Letter “A”)
• Align the TPM interface connector with the connector pins on the server board (See Letter “B”)
•
Gently place the TPM onto the server board connector and push down until fully seated
• Install and tighten the security screw to secure the TPM down to the server board (See Letter
“C”)
Note : Once the security screw is installed, it cannot be removed