Intel M20NTP1UR, Руководство по системной интеграции и обслуживанию

Страница: 35 / 114

Intel® Server System M20NTP1UR - System Integration and Service Guide
35
3.5.2 3.5” Drive Assembly
1. Install the 3.5” drive into the drive carrier (See Figure 31 )
Figure 31. 3.5” Drive Installation to Drive Carrier
• Position the drive interface connector towards the back of the drive carrier
•
Align and position the mounting holes on the left side of the drive over the mounting tabs located
on the drive carrier side rail (See Letter “A”)
•
Lower the right side of the drive into the carrier and press down until all mounting tabs lock in
place.
3.5.3 2.5” Drive Assembly
Installing a 2.5” SSD into the 3.5” drive carrier requires that the supplied drive blank be used as a mounting
bracket for the SSD.
Note: Installing a 2.5” hard disk drive into the 3.5” drive blank is not supported.
1. Convert the drive blank into a mounting bracket (See Figure 32 )
Figure 32. 3.5" Drive Blank to 2.5” SSD Mounting Bracket Conversion
•
Break off the small tab from the side of the drive blank, (see Letter “C”).
Note : Once the tab is removed, it cannot be re-attached to the drive bracket.
2. Position the SSD with its interface connector facing the back of the drive bracket
3. Mount the 2.5” SSD into the mounting bracket (See Figure 33 )