Intec ColorCut SC5000 Series, Руководство пользователя

Страница: 84 / 89

Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................... Page No: 84
11.9 SC5000 - Cutting without Targets (Origin fine tuning)
The SC5000 uses an optical sensor to detect the front edge of the sheets when
fed into the cutter, and the self-centering feed guide system which will correctly
position the Left Side of your sheets.
However due to manufacturing
tolerances, the actual position
of the front or left side of the
sheet may vary slightly. The
Vision3 registration system will
automatically adjust for this, so
this normally these values do not
need to be adjusted.
HOWEVER: If you plan to cut
without registration PageMARK
targets, then you may wish
adjust the SC5000 Options
12
, which controls the origin point
(the point at which cutting starts)
for each sheet loaded.
As typically the values do not need to be adjusted, they are ‘ Locked ’ by default.
To change the values, click on the LOCK
12a
symbol to unlock the fields for
editing.
To Adjust the Feed Advance
12b
(The default value is 0 ) increase or decrease
the value. Increasing the value will advance the sheet further (placing your origin
and any cut lines further down the sheet). Decreasing the value will move the
sheet further back, effectively moving the origin UP the sheet and any cut lines.
To adjust the Left Margin Offset value
12c
,(The default value is 0 ). Increasing
the value will increase the left margin position and move your cut further into the
sheet or decreasing the value (negative values are permitted) will reduce the left
margin, moving the cut out further to (or beyond) the sheet edge.
Important NOTE:
ColorCut Pro, uses cut files containing the
vector lines exported from your artwork.
It does not know your
Page size.
Therefore, when cutting without targets - the cutting
starts from the top corner of any elements ( NOT the edge of your
page ). You can visualise this, by drawing a select marque around
your cutting elements. The TOP corner of this marque will be the
cutting origin (NOT YOUR PAGE !!). Please see the section later
on in this manual to learn how to modify your design to enable
ColorCut Pro to cut relative to your page size. Do NOT edit the
Feed Advance or Left margin Offset values when cutting without
PageMARKs, if you have not adjusted your design to as detailed
in section 14. Excessive changes in these values may affect the
normal operation of your SC5000.
12a
12
12b
12c