INIM smartliving series, Руководство пользователя

Страница: 40 / 64

40 Using the system
Centrali anti-intrusione
•• Beep on output - if enabled, the buzzer will emit audible signals during partition
Exit time.
•• Disable chime - if enabled, the buzzer will not emit audible signals when a bell
zone is violated.
These settings apply only to the keypad you are working on, and will be saved even in
the event of panel shutdown.
Via Keypad
Method 1
Activate the shortcut assigned to “Keypad settings” (shortcut n.18: ), associated
with one of the following keys , ..., shown on the display, with or without
code entry, to access the “Keypad settings” section of the user menu.
1. Use and , followed by to select the parameters to be programmed.
2. Use keys and to increase or decrease the value of the selected
parameter. To activate the selected option press , to deactivate it press .
3. Press to save.
Method 2
Access the “Keypad settings” section of the user menu by typing-in a valid code PIN.
Follow the instructions described in Method 1.
Via Alien touch screen
Access the “Settings” section by tapping the button , type-in a valid user code in
order to access the “Alien” section.
This section will allow you to view the firmware version of the keypad in use on the
connected control panel and change the parameter settings of the keypad you are
working on.
The settings will be saved even in the event of control-panel shutdown.
• Transparency - for the adjustment of the transparency effect
• Brightness - for the adjustment of screen brightness when touched (duration 45
seconds)
• Standby brightness - for the adjustment of screen brightness when the keypad is
in standby status
• Volume buzzer - for buzzer loudness adjustment
• Volume voice - for the adjustment of the speaker loudness
• Skin - for the selection of one of the skins for the Alien touch screen
• Delay photof. - waiting time before the automatic startup of the photoframe
application during standby status
• Photo int. - interval between the display of photos used by the photoframe application
• Language - for the selection of the language used by the Alien touch screen interface
• Temperature adjustment - for the adjustment of the temperature shown on the
display
• View partitions - for the visualization of the operating status of the partitions on
the bottom bar of the display
• Exit time - enables/disables the audible signal during exit time
• Entry time - enables/disables the audible signal during entry time
• Bell - enables/disables the audible signal for the bell function
• Temperature - enables/disables the visualization of the temperature on the display
• Tamper - enables/disables the device tamper function (Alien/G only)
• Maps - enables/disables the automatic start up of the graphic maps application
when the keypad is in stand-by
• Show scenario with code - enables/disables the request for user-code entry when
the user taps the lower bar on the home page to view the active scenarios.
• Emergency lights - if enabled, the keypad brightness will increase to the maximum
value during mains power-cut events and will remain so until the mains power
restores to normal
If the SmartLiving control panel is in maintenance status, a list of the following
parameters will be shown:
• Keypad address
• Keypad address - this is the address of the Alien keypad and its integrated reader
• Tamper - enables/disables the device tamper protection (for Alien/G this option is
shown also when the control panel is not in maintenance status); if tamper is
disabled, the upper tool bar on the home page will show the icon (see opposite).
18:23 01/02/2016
DDDDDDD
User Code
Outputs ON/OFF
Set date/time
Keypad settings
Type in code
******
Method 2
Method 2
Method 2
Keypad settings
Brightness
BrightnessStdby
Contrast
Method 1