Ingeteam Ingecon mWind Interface, Руководство по установке

Страница: 22 / 36

AAY2000IKI06 22
Installation manual Ingeteam Power Technology, S.A.
Any work on any of this equipment and involving a change in the original electrical layout, must first
be proposed to Ingeteam. This proposed new layout must then be studied and authorised by Ingeteam
5. Installation
Before installing the Ingecon
®
μWind Interface, the packaging should be removed, taking particular care not to
damage the enclosure.
The packaging interior should be checked for dampness. Should there be any signs of moisture, then the equipment
should not be used until it has completely dried out.
All installation operations must observe the rules and regulations in force.
Before commencing the steps described in this point, it is important to identify each part described in this section
and to ensure that the right tools are on hand for the installation work.
5.1. General installation requirements
The distance between the Ingecon
®
μWind Interface and the Ingecon
®
µWind must not be more than
3 metres.
• The equipment environment must be suitable, and must comply with the guidelines set out in section “2.
System description”. Furthermore, the items used in the rest of the installation must be compatible with the
equipment and comply with the applicable legislation.
• The ventilation and work space must be suitable for maintenance tasks, in compliance with the rules and
regulations in force.
• The external connection devices must be suitable and must be sufficiently close, as established in the rules
and regulations in force.
• The lead in cables must have a section that is adequate for the maximum current.
• Particular care should be taken to ensure that there are no obstacles blocking the equipment air inlets and
outlets, which would prevent the adequate ventilation of the equipment.
5.2. Wall mounting the equipment
The Ingecon
®
μWind Interface models are equipped with a wall mounting system in the form of an anchor plate.
Follow the steps described below for correct anchorage:
1. Mark the two upper drill points on the wall.
2. Drill holes in the wall with a suitable bit for the screw to be used to hang the equipment.
3. Insert the two screws, made of stainless steel to prevent corrosion, and hang the equipment from the screws.