Ingeteam Ingecon mWind Interface, Руководство по установке

Страница: 18 / 36

AAY2000IKI06 18
Installation manual Ingeteam Power Technology, S.A.
4. Safety instructions
4.1. Contents
This section contains the safety instructions to be followed when installing, operating and accessing the equipment.
Failure to comply with these “Safety Instructions” may result in bodily injury or even death, or cause damage to the
equipment.
Before operating the equipment, please read these “Safety instructions” carefully.
4.2. Symbols
Safety warnings provide information on conditions that could cause serious bodily injury or death and/or damage to
the equipment. Together with the warning sign, instructions are given as to how to avoid such hazards to persons and
equipment.
These symbols are listed below with an explanation of their meaning.
DANGER: electric shock
A warning that the high voltage present in the equipment could cause bodily injury or even death and/
or damage to the equipment.
General warning: regarding conditions that could result in bodily injury and/or damage to the
equipment.
Caution hot surface: warning about the presence of hot parts that could cause serious burns.
All work-specific safety warnings and notes are included in each corresponding chapter and are also repeated and
completed at the critical points in that chapter.
Please read this information carefully. It has been written with your personal safety in mind, whilst
ensuring the maximum service life for the equipment itself and for any devices connected to it.
4.3. Definition of the tasks to be performed
The installation, commissioning, inspection and maintenance operations may only be performed
by suitably qualified personnel, trained to work with electrical equipment (hereinafter qualified
personnel). You are reminded that it is mandatory to comply with all safety regulations and standards
applicable to electrical work.
The opening of the equipment door in no way implies that no voltage is present inside. Access is there-
fore restricted to qualified personnel, observing the safety conditions established in this document.
The set of conditions detailed below should be considered to be the minimum requirements. It is
always advisable to disconnect from the mains. The installation could be faulty, causing undesirable
voltage returns. There is an electrical discharge hazard.