Ingeteam Ingecon mWind Interface, Руководство по установке

Страница: 20 / 36

AAY2000IKI06 20
Installation manual Ingeteam Power Technology, S.A.
requirements, the isolation distance values and the leakage lines for the voltages used.
The tools and/or equipment used for the equipment manipulation tasks must have double reinforced insulation
(class II).
4.4.1. Hazards present and general preventive measures
Impact against stationary objects:
• Inform the workers of the hazard.
• Adequate lighting.
• Work carefully.
• Maintain sufficient distance to avoid contact with the hazard.
Knocks, punctures and cuts with objects and/or tools:
• Keep the cover closed when not working in the cubicle.
• Adequate lighting.
• Good housekeeping.
• Mandatory use of a helmet, safety footwear and gloves when required.
4.4.2. Hazards and additional measures in manipulation tasks
Thermal contact
• Inform the workers of the hazard.
• It is advisable to wear gloves.
• Disconnect the power supply and wait 10 minutes to allow the hot parts inside the equipment time to cool
down.
4.4.3. Personal Protection Equipment (PPE)
It is mandatory to wear safety footwear compliant with standard EN 345-1:1992 . It is also mandatory to wear kid
gloves.
It is also mandatory to wear dielectric gloves that are compliant with the EN-60903-1992 standard and a safety face
mask that provides protection against electric shocks and is compliant with the EN-168-1994 standard for tasks
involving checking voltages.
4.5. Inspection, operational and manipulation tasks
Defined below are the mandatory safety measures required to perform the inspection, operational and/or manipulation
tasks on this equipment.
Opening system: the cover can only be opened and closed by removing or inserting the mounting
hardware.
It is strictly forbidden to access the equipment interior by any point other than the access cover
designed for this purpose.
4.5.1. Inspection tasks
If the equipment interior is to be inspected, then this should only be done through the front cover.
Once the inspection work has been completed, replace the front cover and secure it with the appropriate screws.