IMV K2-CE, Инструкция по эксплуатации

Страница: 11 / 257

1 - 1
Chapter 1 General information
1.1 Before Using this System
Thank you for purchasing IMV Vibration Control System.
This system is used for vibration control to vibration simulation systems and for vibration
measurement.
This system has three principal functions.
1. Excite vibration simulation system
Output analogue drive signals from the dedicated hardware to vibration simulation system.
2. Measure vibration signals
Input analoge signals from sensors to the dedicated hardware and measure vibration signals.
3. Control vibration signals
Control drive signals that the measured signals are equal to the specified references.
< Construction in Standard Use >
This manual provides instructions that you must observe to ensure safe and proper handling of the
vibration control system. Before using this system, please read this instruction manual carefully to
understand the contents thoroughly.
After reading this manual, keep it in place so that you can read it whenever required.
The contents of this manual are subject to change without prior notice in the future.
It is possible to translate into the native language in the country where the vibration test system is
used. If you hope, please contact IMV or our authorized dealer.
IMV Corporation has made constant efforts to provide correct information in this manual. However, if
you have any question about the contents of this manual or find a mistake in writing, please contact us
for improvement by E-mail.
E-mail: info@imv-tec.com
Response Signal
Drive Signal
PCI Express
I/F
K2 IO Unit
Operation PC
Excitation System