Immergas VICTRIX ZEUS SUPERIOR 25, Инструкции и рекомендации, Страница: 8 / 128

8
INS
TALLER
U
SER
M
AINTEN
AN
CE
TECHNI
CI
AN
TECHNI
CAL
D
AT
A
Installation of the boiler when powered by LPG or propane air supply must comply with the
rules regarding gases with a greater density than air (remember, as an example, that it is pro-
hibited to install plants powered with the above-mentioned gas in rooms where the floor is at a
lower quota than the country level).
If installing a kit or servicing the appliance, always empty the system’s domestic hot water circuit first so as not to compromise
the appliance’s electrical safety (Parag. 2.10, 2.11).
Always disconnect the appliance from voltage and, depending on the type of operation, decrease the pressure and/or bring it to
zero in the gas and DHW circuits.
If the boiler is connected to a low temperature direct area, it is necessary to check the necessary flow rate and, if necessary, add a
booster pump.
It is just as important that the intake grids and exhaust terminals are not obstructed.
Check that no flue gas recirculation is found in the air sample points. Allow the appliance to
reach the maximum heat output; theCO
2
value measured in the air must be less than 10% of
that measured on the flue gas.
The minimum distance for exhaust pipes from flammable materials must be at least 25 cm.
Keep all flammable objects away from the appliance (paper, rags, plastic, polystyrene, etc.).
Do not place household appliances underneath the boiler as they could be damaged if the safety valve intervenes, if the drain
trap is blocked, or if there are leaks from the hydraulic connections; otherwise, the manufacturer cannot be held responsible for
any damage caused to the household appliances.
For the aforementioned reasons, we recommend not placing furnishings, furniture, etc. under the boiler.
In the event of malfunctions, faults or incorrect operation, turn the appliance off and contact an authorised company (e.g. the
Authorised Technical Assistance Centre, which has specifically trained staff and original spare parts).
Do not attempt to modify or repair the appliance alone.
Any modification to the appliance that is not explicitly indicated in this section of the booklet is forbidden.
It is forbidden to install appliances removed from other systems.
The manufacturer declines all liability in the event of damage caused by appliances removed from other systems or for any
non-conformities with such equipment.
Before installing the appliance, ensure that it is delivered in perfect condition; if in doubt, contact the supplier immediately.
Packing materials (staples, nails, plastic bags, polystyrene foam, etc.) constitute a hazard and must be kept out of the reach of
children.
If the appliance is installed inside or between cabinets, ensure sufficient space for routine servicing; for minimum installation
distances, see Fig. 3.