IFM Ecomat 300 AC1307, Основное руководство устройства

Страница: 184 / 219

15BError messages
103BProcess error: error codes E10...E30 (AS-i system)
16-4
16.2 Process error: error codes E10...E30 (AS-i system)
•
Error message appears instead of the start screen.
•
No interruption of the menu operation.
• Exclamation mark flashes in the text/graphics display in the middle of the line
at the bottom (only if projection mode is deactivated)
•
The error message disappears again as soon as the error has been corrected.
Error message Cause(s) Solution
E10 Slave not activated
The slave was detected in the system
but not activated by the master.
Detected slave profile does not corre-
spond to the projected slave profile and
the master is in the "protected mode".
►
Check slave profile:
"Menu" > "Slave Info"
→ page 13-48, chapter 13.22 "Display
of slave data"
►
Connect slave with the right profile
► Project slaves again:
"Menu" > "Quick Setup"
→ page 11-15, chapter "End configura-
tion"
E11 Slave not present
Slave present in the "List of projected
slaves" LPS but not detected by the
AS-i master
►
Check connections of the slave
► Connect slave again
E12 Slave not projected
The slave was detected on the AS-i bus
but is missing in the "List of projected
slaves" LPS
► Project slaves again:
"Menu" > "Quick Setup"
→ page11-15, chapter "End configura-
tion"
E13 Peripheral fault detected on at least one
connected slave → page 13-11, chapter 13.6 "Display of
slaves with peripheral fault (list)"
→ page 13-14, chapter 13.7 "Display
slave with peripheral fault"
E14 Safety slave signals alarm Error message not active at present
E15 7.3 Analogue protocol error Error message not active at present
E20 AS-i voltage error
The master is in the "Protected mode"
and detects that the AS-i voltage supply
is not greater than 28 V.
The message is only generated if at
least one slave is projected.
► Check AS-i voltage supply on the
master and – if necessary – replace
E21 No slave detected
The master is in the "Protected mode"
and detects that no slave is connected
to the AS-i bus.
The message is only generated if at
least one slave is projected.
► Check slave connections
► Check AS-i line