IFM Ecomat 300 AC1307, Основное руководство устройства

Страница: 191 / 219

15BError messages
106BSystem errors: error codes M01...M20 (AS-i master command errors)
16-11
16.5 System errors: error codes M01...M20 (AS-i master command errors)
• Menu operation interrupted.
•
Error message superposes menu screen
•
Error message only disappears after:
error has been removed AND
error message has been acknowledged by means of the right function key.
Error message Cause(s) Solution
M01 Error on command execution
An error has occurred during the execu-
tion of an AS-i command which has
stopped the execution of the command.
For further details please refer to the
following error messages.
► Check further error messages
M02 Slave not found
It was tried to access a slave by means
of an AS-i command which is not on the
AS-i bus. The slave is not in the LDS.
► Check connections of the slave
►
Connect slave again
M03 Slave 0 found
The master detects a slave with the
address 0 on the AS-i bus and can
therefore not execute the command.
Example: the address of a slave is to be
changed while a slave with the address
0 is present on the AS-i bus.
► Remove the slave with the address
0 or address it correctly
M04 Slave with the same address found
During the execution of a command the
master detects that there already is a
slave at the requested address on the
AS-i bus.
Example: the address of a slave is to be
changed to an address which is already
occupied by another slave on the AS-i
bus.
►
Remove one of the slaves with
double address
► Readdress the remaining slave
► Reactivate the removed slave
M05 Delete the old slave address
The attempt to reprogram a slave to the
address 0 fails.
Example: the AS-i slave has a limited
number of possibilities to change the
address, these are now exhausted.
►
Replace the slave
M06 Reading the "Extended ID Code 1"
The master does not receive any or an
invalid answer during the retrieval of the
"Extended ID code 1".
Example: attempt to readdress an A/B
slave to another address.
► Repeat the command