IFM Ecomat 300 AC1307, Основное руководство устройства

Страница: 54 / 219

8BMenu
49BMain menu "Slave Setup"
9-12
9.10 Main menu "Slave Setup"
Displaying or changing output data or parameters of individual slaves (password
level 2 required)
WARNING
The output values remain unchanged
Risk of personal injury! Risk of material damage to the machine/plant! After chang-
ing the slave outputs the output values remain unchanged.
The output values only change in the following cases:
•
Manual new setting of the outputs via Slave Setup
•
Starting the PLC program – the program processes the outputs
• Switching the controllere off and on again
► Secure the concerned area.
► Only trained personnel may manually set the outputs.
► Switch the outputs off again immediately after the end of the test.
Menu tree Function
Slave Setup
AS-i Master 1
> Display of the detected slave with the
lowest address on the bus.
►
Scroll through the addresses of the
detected slaves with [ ▲ / ▼ ]
► Select slave address with [
OK
]
Slave Setup
AS-i Master 1
Digital output
> Display of current data of the selected
slave. → page 13-51
►
Change the value of the output signal
with [ ▲ ] / [ ▼ ] and then press [
SET
].
> The row "Current" adopts the setup
value and the change is passed on to
the outputs as long as the active PLC
program in the controllere does not
process these outputs.
► Cancel with [
ESC
].
Slave Setup
AS-i Master 1
Parameter value
> Display of current parameter data of
the selected slave.
→
page 11-19
► Change the value of the parameter in
the row "Setup" with [ ▲ ] / [ ▼ ] and
transmit it to the slave with [
SET
].
> If the value or change is not permissi-
ble: "slave data invalid"
►
Cancel with [
ESC
].
Slave Setup
AS-i Master 1
Analogue value
> Display of current data of the selected
slave (depending on the type of slave):
analogue values.
→ page 13-51
►
After [
OK
]: