IFM Ecomat 300 AC1307, Основное руководство устройства

Страница: 186 / 219

15BError messages
103BProcess error: error codes E10...E30 (AS-i system)
16-6
Error message Cause(s) Solution
E27 Normal operation of the master not ac-
tive
The master reports that it is not in the
"Normal operating mode".
Possible causes:
1. The master detects an AS-i voltage
smaller than 22V and therefore
changes into the "Offline Mode".
2. The master has received a request
from the operating system to pass
into the "Offline Mode".
3. The master has found a transfer
error in the communication with the
operating system.
Other causes which can lead to the
error message directly after the device
has been switched on:
4. Initialisation of the master after
switching on the device was not
successful.
5. The master has not yet received the
projection nor the projected pa-
rameters from the operating system.
6. The master has not yet been started
by the operating system.
On 1:
►
Check the AS-i voltage supply on
the master and replace it – if neces-
sary
On 2:
► Check AS-i voltage supply on the
master and replace it – if necessary
On 3:
► Switch the PLC off and on again
► Replace the controllere and project
again
On 4:
► Switch the PLC off and on again
► Replace the controllere and project
again
On 5:
► Wait.
►
If too long: → 4.
On 6:
► Wait.
►
If too long: → 5.
E28 Safety slave triggered on channel 1. ► Error message not active at present
E29 Safety slave triggered on channel 2. ► Error message not active at present
E30 Safety slave triggered.
The master has detected a "safety
slave" on the AS-i bus and detects that
the inputs of the slave are constantly
switched to LOW for a period of > 64
ms.
► Check slave
► Remove the cause of the error