Idex Hale Sam, Руководство по эксплуатации, установке и обслуживанию

Страница: 47 / 141

31
The PSI Mode governor screen is divided into nine separate areas: System Options and Tab but-
tons, Intake (master) PSI, Statuses and Alerts, Discharge (master) PSI, Mode button, PSI Set
Point icon group, Preset buttons, Pump Capacity, and the Tank Info area. See Figure 32.
The system options button provides access to the data logger controls, Revision Status infor-
mation, and the Password Entry button. (See paragraph 4.3.1.7, page 38.) The Pump Controller
tab buttons: TANK (see paragraph 4.3.1.3, page 34), PUMP INFO (see paragraph 4.3.1.4,
page 35), ENGINE DATA (see paragraph 4.3.1.5, page 37), and VIDEO (if optionally equipped, see
paragraph 4.3.1.6, page 37) are described later in this manual.
The INTAKE PSI icon group (Figure 33) provides a dual format read only indication of the pres-
sure at the pumps intake (master). The center of the icon group provides a digital readout of the
master intake pressure while the outer ring of the icon group provides an analog gauge presenta-
tion of the same pressure.
Figure 33. Intake PSI Components
The screen provides cautions and warnings that in some cases the operator can correct which
are described/listed in section 6.3.7, Operator Responses To SAM Alarms. (See page 106.)
The DISCHARGE PSI icon group (Figure 34) provides both controls and indicators.
Figure 34. Discharge PSI Components
The outer ring provides an analog gauge presentation of the pumps (master) discharge pressure
and an analog presentation of the current set point. The center of the icon group provides a digi-
tal readout (gauge) of the master discharge pressure and is also the target area (drop zone) for
the preset buttons. Directly below the digital gauge is a digital presentation of the current set
point.