Icom ID-E880, Инструкция по эксплуатации

Страница: 36 / 196

18
2
BASIC OPERATION
N
Selecting output power
The transceiver has 3 output power levels to suit your operat-
ing requirements. Low output powers during short-distance
communications may reduce the possibility of interference to
other stations and will reduce current consumption.
± Push [LOW] several times to select the output power.
• “LOW” appears when low output power; “MID” appears when
middle output power; no indication appears when high output
power is selected.
• The output power can be changed while transmitting.
S/RF INDICATOR
POWER OUTPUT
VHF UHF
High:
50 W 50 W
Mid: 15 W* 15 W*
Low: 5 W* 5 W*
*approx.
The microphone can also be used to select output power.
HIGH
4
MID
5
LOW
6
±
Push [
HIGH
4(DTCS)] for high output power;
[
MID
5(DTCS
S
)] for middle output power; and
[
LOW
6(DTMF)] for low output power.
• The output power can be changed via the microphone
during receive only.
N
Operating mode selection
Operating modes are determined by the modulation of the
radio signals. The transceiver has total 5 operating modes
(FM, FM-N, AM, AM-N and DV modes)
. The mode selection is
stored independently for each band and memory channel.
Typically, AM mode is used for the air band
(118–136.995 MHz)
,
and only receive is available.
q
Select the desired frequency band in the VFO mode, or the
desired memory channel.
w
Push and hold [MODE] (BAND) for 1 sec., then rotate
[DIAL] to select the desired operating mode between FM,
FMN, AM, NAM and DV.
• Push [MODE] (BAND) again to return to the frequency indica-
tion.
[DIAL]
[MODE]
Selected operating mode is displayed.
FM FMN
NAM AM DV