61
11
DIGITAL MODE OPERATION
D
D
Your own call sign programming
Your own call sign must be programmed for both digital voice
and low-speed data communications
(including GPS transmis-
sion)
.
q
Push
[SET•LOCK]
to enter call sign set mode.
• Rotate
[DIAL]
to select “CALLS,” if “SET” or “MESSAG” is dis-
played.
w
Push
[SET•LOCK]
or
[S.MW•MW]
several times to select
“MyCALL,” then push
[BAND•MODE]
.
e
Rotate
[DIAL]
to select the desired call sign channel from
“M01” to “M06.”
r
Push
[BAND•MODE]
for 1 sec. to enter call sign program-
ming mode.
• The 1st digit blinks.
t
Rotate
[DIAL]
to select the desired character or code.
• Push
[SET•LOCK]
or
[S.MW•MW]
to move the cursor right or
left, respectively.
y
Push
[SET•LOCK]
to select 2nd digit, then rotate
[DIAL]
to select the desired character or code.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming your own call sign.
u
Push
[BAND•MODE]
for 1 sec. to save the call sign and
enter the note programming mode.
• Up to a 4-digit of note (operating radio type or area) can be set.
i
Push
[BAND•MODE]
for 1 sec. to save the note and exit
the note programming mode.
o
Repeat steps
e
to
i
to program other call sign channels.
!0
Push one of
[TONE•T-SCAN•BK]
,
[LOW•DUP]
or
[MONI•DTMF•EMR]
to exit call sign set mode.
NOTE:
During the call sign programming mode
(
r
to
u
)
,
push
[V/MHz•SCAN
] to clear the entered call sign
(the cur-
sor returns to the 1st digit position)
, push
[V/MHz•SCAN]
again to display the previously saved call sign.
ID-800H_1.qxd 2007.06.14 3:09 PM Page 61