90
11
DIGITAL MODE OPERATION
11
■
Low-speed data communica-
tion
In addition to the digital voice communication, a low-speed
data communication is available.
q
Turns OFF the transceiver
w
While pushing
[SET•LOCK]
, push and hold
[PWR]
for
1 sec. to enter initial set mode.
(see p. 104)
e
Push
[SET•LOCK]
or
[S.MW•MW]
several times to select
the data communication speed setting.
(see p. 110)
• “SPD” appears.
• Rotate
[DIAL]
to select suitable data speed for your PC or appli-
cation.
r
Push
[PWR]
to exit initial set mode, then set the desired
frequency.
t
Set repeater call signs, transmit output power and other
conditions.
y
Push
[SET•LOCK]
to enter set mode.
• Rotate
[DIAL]
to select “SET,” if “CALLS” or “MESSAG” is dis-
played.
u
Push
[SET•LOCK]
or
[S.MW•MW]
several times to select
the automatic data transmission setting.
(see p. 99)
• “DVT” appears.
• Skip this setting, if you want to transmit manually.
i
Start up the low-speed data communication application.
o
Set the application as follows.
• Port
: The same COM port number as ID-800H’s
• Baud rate
: 4800 bps or 9600 bps (same as step
e
)
• Data
: 8 bit
• Parity
: None
• Stop
: 1 bit
• Flow control : Xon/Xoff
!0
Transceiver automatically transmits or receives the data
while the computer is sending data to transceiver. Or push
and hold
[PTT]
to transmit, release to receive the data
manually.
• Refer to the instructions of the application that how to send or re-
ceive data.
ID-800H
Personal computer
to [DATA] socket
to RS-232 port
OPC-1384
[DATA]
socket
Rear view
ID-800H_1.qxd 2007.06.14 3:09 PM Page 90