IBM XSERIES 255 TYPE 8685, Руководство по техническому обслуживанию и ремонту

Страница: 82 / 226

v
You cannot install hot-swap hard disk drives or non-hot-swap hard disk drives in
the right-front bays (bays A through D). You can install hot-swap hard disk drives
only in the hot-swap hard disk drive bays on the left-front side of the server.
v Your server supports a maximum of six standard 26 mm (1-inch) slim-high,
3.5-inch, hot-swap hard disk drives in the hot-swap bays. The standard hot-swap
bays are bays 1 through 6, located in the standard (upper) drive cage.
v You can install six additional hot-swap hard disk drives in the server after you
install the optional 6-Pack hot-swap backplane in the optional (lower) drive cage.
The optional hot-swap bays are bays 7 through 12, located in the optional (lower)
drive cage.
v
The SCSI IDs for the hot-swap drives are printed on the bezel, immediately
adjacent to the hot-swap drive bays. The IDs are:
– 0 through 5 for bays 1 through 6
– 10 through 15 for bays 7 through 12
v The server does not support half-high hot-swap drives.
v
To minimize the possibility of damage to the hard disk drives when you are
installing a hard disk drive in a rack model, install the rack model in the rack
enclosure before installing the hard disk drives.
v
You do not have to turn off the server to install hot-swap drives in the hot-swap
drive bays. However, you must turn off the server when performing any steps
that involve installing or removing cables.
v Before you install any internal drives in a tower model server, you must first
remove the bezel (see “Removing the bezel (tower model)” on page 50). Before
you install 5.25-inch removable-media drives in a rack model server, you must
first remove the bezel (see “Removing the bezel (rack model)” on page 49).
v
Your server supports one IDE device. You must first disconnect the IDE cable
from the CD-ROM drive that comes with your server and remove the CD-ROM
drive before you install another IDE device.
Note: Attach the black connector end of the IDE cable to the IDE device; attach
the blue connector end of the IDE cable to the system board.
v
For a list of supported IDE and SCSI options for your server, go to
http://www.ibm.com/pc/us/compat/ on the World Wide Web.
72
xSeries 255 Type 8685: Hardware Maintenance Manual and Troubleshooting Guide