IBM XSERIES 255 TYPE 8685, Руководство по техническому обслуживанию и ремонту

Страница: 71 / 226

Tab
Fan bay 7
(fan removed)
Captive screw
Cable-management
arm
Cable-management
arm bracket
1) Remove the fan from fan bay 7.
2) Insert the tab on the cable-management-arm bracket into the
corresponding slot on the server.
3) Tighten the captive screw on the cable-management-arm bracket to the
server.
4) Reinstall the fan in fan bay 7.
17. If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation” on page 104.
Working with the optional xSeries 6-Pack Hot-Swap Hard Drive
Expansion Kit
Your server contains hardware that enables you to replace a failed hard disk drive
without turning off the server. Therefore, you have the advantage of continuing to
operate your system while a hard disk drive is removed or installed. These drives
are known as hot-swap drives. The hot-swap drives are attached to a hot-swap
hard disk drive backplane . The backplane is a printed circuit board behind the drive
bays. For more information about drive bays and drive installation, see “Installing
internal drives” on page 71. The low voltage differential (LVD) SCSI hot-swap hard
disk drive backplane supports a maximum of six slim-high, hot-swap hard disk
drives.
If you install the optional 6-Pack hot-swap drive backplane, you can attach up to six
additional drives. The optional xSeries 6-Pack Hot-Swap Hard Drive Expansion Kit
Chapter 4. Customer replaceable units
61