IBM XSERIES 255 TYPE 8685, Руководство по техническому обслуживанию и ремонту

Страница: 104 / 226

Captive screws
Heat sink
Microprocessor
VRM
VRM clip
88
Microprocessor
baffle
Microprocessor
orientation indicator
Microprocessor
release lever
d. Center the VRM over the connector. Make sure that the VRM is oriented
and aligned correctly. The bottom edge of the VRM is keyed and can be
inserted only one way.
e. Carefully but firmly push down the VRM to seat the VRM in the connector.
Be sure that the bottom sides of the retainer clip snap into place on the
sides of the connector.
6. Remove the flat, plastic cover from the empty microprocessor socket.
If you are installing a microprocessor in socket 4, remove the plastic
microprocessor baffle from socket 4. Store the plastic microprocessor baffle in
a safe place. If you remove the microprocessor and heat sink from socket 4,
you must reinstall the microprocessor baffle in that socket.
7. Install the microprocessor:
a. Touch the static-protective package containing the new microprocessor to
any unpainted metal surface on the server; then, remove the
microprocessor from the package.
b. Rotate the locking lever on the microprocessor socket from its closed and
locked position until it stops or clicks in the fully open position
(approximately 135° angle), as shown. Then, see the documentation
provided with the microprocessor option for complete installation
instructions.
Attention: You must ensure that the locking lever on the microprocessor
socket is in the fully open position before you insert the microprocessor in
the socket. Failure to do so might result in permanent damage to the
microprocessor, microprocessor socket, and system board.
94
xSeries 255 Type 8685: Hardware Maintenance Manual and Troubleshooting Guide