I.58015
[I.58015] Memory spare copy initiated.
Explanation:
Spare Copy Started
Severity:
Info
User response:
Information only; no action is required.
I.580A4
[I.580A4] Memory population change detected.
Explanation:
DIMM Population Change Detected
Severity:
Info
User response:
Check the event log for any events related to uncorrected DIMM failures and resolve those issues.
I.580A5
[I.580A5] Mirror Fail-over complete. DIMM number % has failed over to the mirrored copy.
Explanation:
DIMM Mirror Fail-over Detected
Severity:
Info
User response:
Check the event log for any events related to uncorrected DIMM failures and resolve those issues.
I.580A6
[I.580A6] Memory spare copy has completed successfully.
Explanation:
Spare Copy Complete
Severity:
Info
User response:
Check the event log for any events related to uncorrected DIMM failures and resolve those issues.
S.1100C
[S.1100C] An uncorrectable error has been detected on processor %.
Explanation:
An uncorrectable processor error was detected.
Severity:
Error
User response:
Complete the following steps:
1.
Check the IBM support site for service bulletins or firmware updates that apply to this processor error.
2.
Reboot the system. If problem persists, contact Support.
S.2011001
[S.2011001] An Uncorrected PCIe Error has Occurred at Bus % Device % Function %. The Vendor ID
for the device is % and the Device ID is %.
Explanation:
PCI SERR Detected
Severity:
Error
User response:
Complete the following steps:
1.
If this system or any attached cables were installed, moved, serviced or upgraded recently, complete the
following steps:
v
Reseat the adapter and any attached cables.
v
Reload the Device Driver.
v
If the device is not recognized, reconfiguring slot to Gen1 or Gen2 might be required. Gen1/Gen2 settings can
be configured via F1 Setup -> System Settings -> Devices and I/O Ports -> PCIe Gen1/Gen2/Gen3 Speed
Selection, or by using the ASU Utility.
2.
Check IBM support site for any device drivers, firmware updates, or other information that applies to this error.
Load new device drivers and install any required firmware updates.
3.
If problem persists, remove the adapter. If system reboots successfully without the adapter, replace that adapter.
4.
Replace the processor.
I.58015 • S.2011001
304
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
Содержание System x3750 M4 Type 8733
