IBM System x3750 M4 Type 8733, Инструкция по установке и обслуживанию

Страница: 295 / 694

Tray handle
Microprocessor
and memory
expansion tray
Power supply 2
10. Grasp both handles (front and rear) and lift the tray assemble from the server
and set it on a flat surface to avoid damaging the connector pins on the
bottom of the tray.
11. Remove the microprocessors (see “Removing a microprocessor and heat sink”
on page 272 for instructions on how to remove a microprocessor).
Note: When you remove the microprocessors from the old tray, install the
microprocessors directly from the old tray to the new tray with the
microprocessor installation tool.
12.
If you are instructed to return the microprocessor and memory expansion tray,
follow all packaging instructions, and use any packaging materials for
shipping that are supplied to you.
Replacing the microprocessor and memory expansion tray
assembly
To install the microprocessor and memory expansion tray, complete the following
steps:
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 33.
2. Grasp the tray by both handles, align the tabs on the sides of the
microprocessor and memory expansion tray with the slots on the chassis wall,
and lower the tray into the server.
Note:
Before you install the new tray, make sure that there is no packaging
material underneath tray.
Chapter 6. Removing and replacing components
279