IBM System x3750 M4 Type 8733, Инструкция по установке и обслуживанию

Страница: 223 / 694

Replacing the server top cover
To install the server cover, complete the following steps:
1. Make sure that all cables, adapters, and other components are installed and
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
2. Align the cover over the server (toward the rear of the server) until the cover
edges slip into position over the chassis.
Cover release
latch
Top cover
3. Slide the cover toward the front of the server; then, press down on the cover
release latch until it clicks into place.
4. Slide the server back into the rack cabinet until it latches.
5. Reconnect the external cables and power cords.
Removing the bezel
To remove the bezel, complete the following steps:
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 33.
2. Turn off the server (see “Turning off the server” on page 21) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Slide the server out of the rack.
4. Remove the screws from the bezel with a Torx screwdriver.
Chapter 6. Removing and replacing components
207