IBM System x3690 X5, Руководство по обслуживанию, Страница: 400 / 464

Replacing a MAX5 hot-swap fan
To replace a hot-swap fan in the MAX5 expansion module, complete the following
steps:
Note: For more information about how the fan event messages are issued and the
fan number and the device on which the fan is located, see “System-event log” on
page 167 and Table 9 on page 167.
1. Align the new fan with the slot in the fan cage.
2. Slide the fan into the fan slot until it snaps into the connector firmly.
3.
Reinstall the bezel (see “Replacing the MAX5 bezel” on page 376).
Removing a MAX5 memory module
To remove a memory module from the MAX5 memory expansion module,
complete the following steps:
1. Read the safety information and installation guidelines, see “Safety” on page vii
and “Installation guidelines” on page 261.
2. Turn off the host server (see “Turning off the server” on page 17) and all
attached peripheral devices. Disconnect all power cords; then, disconnect all
external cables from the server. Disconnect all power cords from the MAX5;
then, disconnect all external cables from the MAX5 as necessary to replace the
device.
3. Remove the bezel (see “Removing the MAX5 bezel” on page 376).
4.
Grasp the blue release tabs on the system-board tray latches and pull the
latches in opposite directions to release the tray from the chassis.
382
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide