IBM System x iDataPlex dx340, Руководство по диагностике и обслуживанию

Страница: 142 / 196

Installing a 2x2 2.5-inch hot-swap SAS backplane
To install a 2x2 2.5-inch hot-swap SAS backplane in the I/O enclosure, complete
the following steps.
2x2 2.5-inch hot-swap
SAS/SATA backplane
Locating pin
holes
1. Touch the static-protective package that contains the 2x2 2.5-inch hot-swap
SAS backplane to any unpainted metal surface on the outside of the I/O
enclosure; then, remove the 2x2 2.5-inch hot-swap SAS backplane from the
package.
2. Place the 2x2 2.5-inch hot-swap SAS backplane on the locating pins inside the
I/O enclosure.
3. Install the retaining screws.
4. Reconnect the cables to the 2x2 2.5-inch hot-swap SAS backplane.
5. Install the 2.5-inch hot-swap hard disk drives, if you removed any from the I/O
enclosure (see “Installing a 2.5-inch hot-swap hard disk drive” on page 89).
6. Install the I/O enclosure (see “Installing an expansion enclosure on a
system-board tray” on page 74).
7. Install the system-board tray in the chassis (see “Installing the system-board
tray in a 2U chassis” on page 76).
126
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide